Instructions for use LITEC 2G
17
Drive Medical GmbH & Co. KG | As per: 22.06.2020 | Errors and alterations excepted
EN
respective brake (
photo 17) and push the complete unit
onto the guide such that there is a distance of 10 mm
between the brake bolt and the tire (
photo 18). Retigh-
ten both screws and the parking brake is now optimally
adjusted.
Ensure that all screws are reinserted and tightened!
To use the parking brake, press the brake lever fi rmly
from the front until it noticeably clicks into place – the
parking brake is now engaged (
photo 19).
To release, pull the brake lever towards you and the par-
king brake is unlocked (
photo 20).
19
20
Always ensure that the parking brake is locked by att-
empting to move the wheelchair.
To facilitate transferring into and out of the wheelchair,
the operating lever of the parking brake can be folded
down.
(photo 21+22). To do this, pull the lever upwards
and then fold it down.
21
22
Adjusting the backrest and cushion
The tension of the backrest cover can be adjusted in po-
sition 1 and 2
(photo 11+12).
11
12
Adjusting and removing armrests
The armrests are already assembled on the wheelchair
upon delivery. The armrest overlays are replaceable. The
armrest overlay can be adjusted as a short or long arm
support, as needed
(photo 13+14). To adjust it, loosen
the screws on the underside and move the armrest into
the desired position.
Retighten the screw!
13
14
To swivel the armrest backwards, engage the release le-
ver at the front of the arm rest and hold it down it while
simultaneously pulling the armrest up until the armrest is
free. Now it can be swiveled backwards
(photo 15+16).
15
16
Adjusting and using the parking brake
Upon delivery, the parking brake is correctly adjusted
according to the confi guration status. If you have made
changes to the wheel position, the brake adjustment
may need to be changed.
To do this, remove both screws on the underside of the
17
18
