Drinkwell D360SSKA-RE, Руководство по эксплуатации

Страница: 8 / 32

www.petsafe.net 9 8 www.petsafe.net
EN
KO
8. Look into the Cone opening and make sure the
Intake Tube is sticking straight up from the Motor
(
fig. 7
). Carefully, insert the Filter Housing into the
cone opening and push straight down (
fig. 8
). By
pushing the Filter Housing all the way down to the
rubber gasket, the Housing should easily attach to
the Intake Tube.
9. Select one of the five interchangeable Spout Rings
based upon your personal preference or your pet’s.
Place the chosen Spout Ring on top of Filter Housing
Cap and gently press down to secure in place (
fig. 9
).
fig. 8
fig. 10
Raised notches
fig. 9
Raised notches
10. On the Filter Housing Cap, align the Flow Control Cap with the raised notches
(
fig. 10
). Press down gently and the Flow Control Cap will snap into place. With
the Flow Control Cap, you will be able to easily adjust the intensity of the water
flow. Turn the Flow Control Cap to the right to increase the flow of water and turn
to the left to decrease.
ImpORtAnt:
If you notice a decrease in the flow of the
water that is not corrected by increasing the flow control to max flow, this may be
an indication of a clogged and dirty Filter and/or the need to rinse and clean the
Filter Housing. Consult the “Pet Fountain Disassembly and Cleaning” section of this
manual for details on cleaning and maintaining your Pet Fountain.
11. Take one of the plastic Cord Clips and align with the electrical Power Cord
hanging over the rim of the Bowl. With the two-prong end on the outside of the
Bowl (
fig. 11
), slide the Cord Clip all the way down until it clips onto the bottom
of the Bowl (
fig. 12
).
12. Take the other two plastic Cord Clips and attach them to the Bowl so that the three clips
together form the three points of a triangle (
fig. 13
). This will lock the Cone in place.
fig. 7
fig. 11
fig. 12
fig. 13