SKU 67042
For technical questions, please call 1-800-444-3353.
Page 8
operating inStruCtionS
read the entire important
SaFety inFormation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tool Set up
to preVent
SeriouS inJury
From aCCidental
operation:
turn the tool off (0 position)
and remove Battery pack
before tool Set up.
Cutout Bit replaCement:
1.
to preVent
inJury and
BurnS:
allow Cutout Bit to cool
completely and wear heavy-
duty work gloves before
touching the Cutout Bit.
the Cutout Bit gets very hot
during operation.
(Base plate
and Base plate
Support removed
for clarity)
Collet nut
Collet
Spindle
lock
a.
Hold in the Spindle Lock while
loosening the Collet Nut, turning it
counterclockwise.
Remove the Cutout Bit.
b.
Check the size of the new Cutout Bit.
c.
the Collet muSt match the shaft
size.
The Collet can be replaced if
the Collet Nut is removed.
Inspect the new Cutout Bit. It must
d.
be undamaged, unbent, designed for
use on cutout tools (not a drill bit),
and designed to rotate in the same
direction as the arrow next to the
Spindle Lock.
Insert the new Cutout Bit fully into
e.
the Collet. Tighten the Collet Nut
securely.
BaSe plate (15) adJuStment:
2.
Loosen Lock Screw (9), move Base
Plate (15) to desired height and
tighten Lock Screw (9) - see Figure A.
CirCle Cutting guide (14)
3.
Setup:
Remove the Bit.
a.
Circle
guide
Bracket
disk
nut
Circle Size
Knob
Circle
Cutting
guide
Ball
Knob
Figure B
b. Place Circle Guide Bracket (16) into
Base Plate (15) with the threaded
portion facing downward. Turn it so
that it fits snugly into place.
Place Circle Cutting Guide (14) over
c.
the threaded portion of the Circle
