DRESSTA 32501, Руководство оператора

Страница: 69 / 177

OPERATING
SECTION 4
Page 23
DRESSTA TD-15H
4.10. CONVERTER OVERHEATING
If the pointer of the torque converter oil temperature gauge moves out of the RUN area of the dial
during operation, the transmission may be in a gear range which is too high for the load. Shift
down into the next lower gear range. The temperature should reduce; if not, downshift again. If the
dial pointer remains out of the RUN range in the first gear, stop the machine, shift into neutral and
run the engine at 1000 [RPM] until the gauge pointer moves into the RUN area. Stop the engine,
check transmission oil level, clean radiator and suction filter.
If the converter still remains overheated, stop the engine and consult Authorized Distributor of
Construction Equipment before operating the machine.
4.11. STEERING THE MACHINE
Steering is accomplished with two steering levers. Each of the two levers functions in three
positions as shown in Fig. 4.20.
•
in forward position A transmits power to the track in high range
•
in middle position B transmits the power to the track in low range
•
in rearward position C disconnects the power and applies the brake
To turn to the right or left pull back the steering lever on the side toward which the turn is to be
made. Pull lever back just enough to make the desired turn. To make a pivot turn pull the lever all
the way back.
To make a gradual left turn proceed as follows:
With steering lever in the high range move the LH steering into the low range. When both steering
levers are in the low range, move the RH steering lever into the high range. To make a gradual
right turn proceed in the similar manner.
Machines with 1-speed steering have not high range.
Fig. 4.20. Steering Levers
A. High Range B. Low Range C. Pivot
https://www.truck-manuals.net/