© NEUREITER | Original-Manual Version 2.0
15
Headstock
The headstock consists of the housing, pulleys with gear
ratio, spindle with M33 x 3.5 mm thread as well as a No. 2
Morse taper (MT2), cover for pulleys, 24-position indexing,
handwheel and an 80 mm faceplate.
Replacing the 4-prong spur center
Using the supplied knock out bar, the 4-prong spur center
can be pushed out from the rear through the spindle shaft. In-
itially, try to push out the spur center with gentle taps. During
this process, carefully hold on to the outside of the 4-prong
spur center with your other hand. Do not hold on to the 4-pro-
ng spur center at its face or by the jaws as this can cause
injuries.
•
To begin with, check that the machine has been set up and assembled correctly.
•
Before commissioning, remove all loose parts and tools that may be lying on the lathe.
•
On the movable control unit, turn the toggle switch to „forward“ and turn the potentiometer all the way to the left, to zero.
•
Insert the safety plug into the designated isolated socket.
•
To start the machine, press the green button (I) on the movable control unit.
•
By turning the potentiometer, you are increasing the speed to the required rpm
When starting the lathe with a work piece inserted, ensure the potentiometer is on „0“. Then press the green ON button
to turn on the speed.
Lathe bed and other parts like components and accessories are coated with corrosion preventative grease and have to be
cleaned before assembling. This is best done with a degreaser and paper towels.
Fig. 14
Fig. 15
9. Commissioning
10. Using the wood turning lathe
