© NEUREITER | Original-Manual Version 2.0
13
Lathe assembly
Using at least two persons, lift the MIDITEC FU-175 turning lathe out of the polystyrene packing and onto an appropriate base.
Pay attention to the connected supply cables of the frequency converter and the moveable control unit.
Mounting the frequency converter.
The left lower cover plate of the FC is pushed over the screw shaft on the mounting plate (Fig. 9) on the rear of the headstock.
Then the FC is fixed on the upper right side with a second screw (Fig. 10). Both screws must finally be tightened.
Use the located screws to fix the hinge for the bed cover.
(Fig. 11 )
Before the plugs of the frequency converter and the speed
sensor are connected (Fig. 12) to the plug coupling of the
digital speed display a cable protection conduit is pushed
about the supply cables. When plugging the components to-
gether be sure, that they audibly engage. By the design the
cable connections could not be mixed by mistake. Finally the
cable protection conduit is pushed over the plug-in contacts
(Fig. 13).
Fig. 9
Fig. 12
Fig. 11
Fig. 10
Fig. 13
