FLEX Shower Door Manual Ver 2 Rev 8 01/2018
© 2018 DreamLine. All Rights Reserved
15
14.
Attach the Flanged Anti-water strip (07) to the vertical edge of the
Stationary glass.
Open the door and attach the Bottom Anti-water strip (08) to the
bottom of the door glass from the pivot to the edge of the magnetic
strike rail and trim off the excess. Next, attach the cut off to the
bottom of the door glass, opposite of the pivot and trim to fit.
Attach both pieces of the Bottom Anti-water strip (08) to the
bottom edge of the Glass door.
See Fig. 17 for details.
15.
Apply a good quality, mildew-resistant silicone along
the wall profiles and the bottom expanding rail
where they meet the walls and threshold from both
inside and outside the shower.
Allow 24 hours for the silicone to fully cure before
first use.
See Fig. 18 for details.
Caulk
Fig
. 17
Fig
. 18
outside
NOTE: Measure to the strike edge of the
door and notch the Bottom anti-water
strip (#08) with a razor knife to fit around
the magnet strip, leaving the bottom
sweep intact.
