“ENIGMA Z” Enclosure Rev.1 Ver.1 05/2013
12
13.
Drill the holes using
Ø 5/16
drill bit and insert the
Wall
anchors (9b)
for the
Wall bracket (19)
. Drill the holes
for the
Rail brackets (08)
using
Ø 3/8”
drill bit and
insert the
Wall anchors (9a)
.
Mount the
Wall bracket
to the wall using the
Big flat
head screw ST4.2×55 (18).
Mount the male parts of the
Rail bracket
onto the wall
using the
Round head screw ST6×55 (10)
.
See Fig. 15 for details.
Fig. 15
14.
Place the
Guide Block (12)
on the shower
base or the threshold and place the
Stationary glass (02)
back into the
designated position so it gets in the groove
of the
Guide block.
Fasten the female part of the
Guide rail
bracket (08)
to its male part on the wall.
Tighten the set screws on the
Guide rail
brackets
to secure the
Upper Guide rail
between the wall and the
Return Panel (22)
.
Assemble the
Wall bracket (19)
at the
bottom corner of the
Stationary glass
and
tighten the bolt.
Put the level to the
Upper Guide rail
and
use hex spanner wrench to adjust
Guide rail
bracket
on the wall until the top rail is
absolutely vertical. Tighten the screws on
both sides of the
Guide rail bracket
.
See Fig. 16 and Fig. 17 for details.
Fig. 16
Ø5/16"
Ø 3/8"
1
3
2
4
5
6
3
4
1
2
