6A
6B
4
3B
3B
E F
E F
G
G
7B
7A
7C
Indicator
Lines
8A
6.
Insert the Bolts with Rubber Pads and Tension Knobs into the Gate Frame, then partially slide the Bolts with Rubber Pads and Tension
Knobs outwards into the Wall Cups
(6A & 6B)
.
Keep this gap about 0.04in / 1mm
8B
8.
Tighten the Tension Knobs until the two Indicator Lines (X), located on the Upper Locking Set and on the Right Upper Corner, align
horizontally
(8A)
.
Distance
should be
equal
When correctly tightened,
the distances between
Tension Knobs and Rubber
Pads should be equal (8B).
Y=Y
X=X
7.
Tighten both of the bottom Tension Knobs (E) by turning them at the same time
(7A & 7B)
.
NOTE:
Make sure the bottom of the gate frame remains completely flat on the floor.
Next, tighten both of the Tension Knobs
(E)
at the top by turning them at the same time
(7C).
INSTALLATION
NOTE:
When first installing,
the gate will have this gap.
This is normal and will
disappear when gate is
completely installed.
Tighten inward
D
E
Y
X
Y
X
MAX
5.5cm
2.15in
MAX
5.5cm
2.15in
6
