Drazice TO 10 IN/UP, Руководство по эксплуатации и установке

Страница: 32 / 54

- 32 -
E
N
For safety reasons setting of optional highest temperature in the water heater is possible according to the
below instructions:
a) Insert a screwdriver in opening 1 and remove the cap of
knob 2,
b) Set the range in the selector knob 3
to the desired temperature,
C - 35 °C
B - 45 °C
A - 55 °C
O - 75 °C
c) Refit the cap of knob 2 onto the knob casing.
The electric heater operation is indicated by a control light that is on until the water in the heater heats up
to the selected temperature, or until switched off as scheduled. Due to heating, the volume of water
increases, which causes water dripping from the combination faucet pipes. You will not prevent water from
dripping by strong tightening of the handle on the combination faucet but you may damage the faucet.
If you do not intend to use the heater constantly, you need to protect the water in the heater by not
discontinuing the power totally and setting the thermostat selector to position "*". At such setting the
heater is maintained at the approximate temperature of 9°C. If you take the heater off the power supply,
you have to drain the water from it if there is a risk that the water inside freezes. Clean the outer parts of
the appliance with a mild detergent solution. Do not use thinners or other aggressive cleaning agents.
Through regular service inspections you will ensure trouble-free operation and long service life of the
heater.
We recommend that the first inspection of the heater was performed by a specialist,
approximately after two yours following its putting in operation.
During the inspection the scale, that will accumulate inside the heater depending on the quality, amount
and temperature of the water consumed, will be removed as needed. During the inspection of the heating
element, the service technician will advise of the date of the next inspection, taking into consideration the
found condition of the appliance.
WARNING:
Prior to any intervention in the inside of the heating element, the appliance has to be
disconnected from power supply!
Do not attempt to repair the heater by yourselves, call the nearest authorised service
centre to do so.