Draytek VigorAccess-A48M-2-SFP-A-1-AC, Руководство пользователя

Страница: 10 / 63

Ethernet Bridging
IEEE 802.1d STD transparent bridging
Up to 4000 MAC entries address table
Port-based VLAN
IEEE 802.1Q Tagged VLAN
VigorAccess uses the IEEE 802.1Q Tagged VLAN; users can allow this device to
deliver tagged/untagged frames in these ports. VigorAccess supports up to 512
VLAN groups and can be applied up to 4094 VLAN identifications.
IEEE 802.1p Priority
VigorAccess supports IEEE 802.1p to assign priority levels to all individual ports.
Users can set different quality of service for individual application.
For example, voice and video services can set high priority and Internet data service
will be lower priority.
Support 4 queues for per ATM port.
Support 8 queues for per physical Ethernet port.
MAC Address (Media Access Control) Filter
VigorAccess can let users use the MAC filter for incoming frames based on
MAC (Media Access Control) addresses that specified by users. Users can
enable/disable this function on specific port.
Access Control List per port is up to 8 entries. If port receives a packet which
source MAC address is met with one of the 8 entries, this packet can be
forwarded to destination port.
Access Control List per device is up to 1024 entries. If port receives a packet
which source MAC address is met with one of these entries, this packet would
not be forwarded to destination port.
The high priority of ACL rules is the allowing rule checking for per port.
MAC Address (Media Access Control) Count Filter
VigorAccess supports users to limit the number of MAC addresses that may be
dynamically learned or statically configured on a port. Users can enable/disable this
function on individual ports.
The global static learning table has up to 512 entries. Each entry can be set to a
specific port. In dynamic learning mode, there are 16 MAC address entries in DSL
port and 256 entries in Ethernet uplink port.
Multi-Protocol Encapsulation
VigorAccess supports multi-protocol encapsulation over ATM adaptation Layer 5
based on RFC2684.
Management
VigorAccess supports some management method as listed below.
Remote configuration backup/restore via EMS client/server.
Remote firmware upgrade
SNMP management
Command Line Interface, it can be accessed by local Console or Telnet
interface.
User’s Guide
2