Vigor3300 Series User’s Guide
50
F
F
o
o
r
r
L
L
A
A
N
N
I
I
P
P
/
/
D
D
H
H
C
C
P
P
In the Vigor3300 Series router, there are some IP address settings for the LAN interface. The
IP address/subnet mask is for private users or NAT users. The IP address of the default
gateway on other local PCs should be set as the Vigor3300 Series’ server IP address. When
the DSL connection between the DSL and the ISP has been established, each local PC can
directly route to the Internet. The IP address/subnet mask can also be used to connect to other
private users (PCs). On this page you will see the private IP address defined in RFC-1918.
Usually we use the 192.168.1.0/24 subnet for the route.
IP Address
Type the IP address for LAN/DHCP.
Subnet Mask
Type the subnet mask for the LAN IP/DHCP.
Status
Click
Enable
the DHCP server; click
Disable
to close DHCP
server; click
Relay Agent
to close DHCP sever and do the job
of DHCP server. Corresponding settings for Relay Agent can be
configured in the page of
DHCP Relay Agent
.
Start IP
Set the starting IP address of the IP address pool for DHCP
server.
End IP
Set the ending IP address of the IP address pool for DHCP
server.
Primary DNS
Set the private IP address of the primary DNS.
Secondary DNS
Set the private IP address of the secondary DNS.
Lease Time (Min)
Set a lease time for the DHCP server. The time unit is minute.
Gateway IP (Optional)
Set a gateway IP address for the DHCP server.
Содержание Vigor3300 Series
Страница 1: ......
Страница 152: ...Vigor3300 Series User s Guide 146 This page is left blank ...
Страница 182: ...Vigor3300 Series User s Guide 176 FXO card This card can connect to PSTN inside lines of PBX and FXS port on FXS cards ...
Страница 185: ...Vigor3300 Series User s Guide 179 Port Settings Port Edit Configure related VoIP settings for each port respectively ...