Vigor2820 Series User’s Guide
47
Enable
Check this box to enable that channel. Only channel 3 to 8 can be
set in this page, for channel 1 to 4 are reserved for NAT using.
P1 to P4
It means the LAN port 1 to 4. Check the box to designate the LAN
port for channel 3 to 8.
Service Type
Normally, service type is used for the service of video stream (e.g.,
IPTV). It can divide the packets from remote control and from
video stream into different PVC. In general, the protocol used by
remote control is IGMP.
Normal
– It means that the PVC can accept all packets except
IGMP.
IGMP
– It means that the PVC can accept packets of IGMP only.
Add Tag
To identify the usage of PVC, check this box to invoke this setting.
And type the number for VLAN ID (number).
Click
Clear
to remove all the configurations in this page if you do not satisfy it. When you
finish the configuration, please click
OK
to save and exit this page. Or click Cancel to abort
the configuration and exit this page.
3
3
.
.
1
1
.
.
6
6
L
L
o
o
a
a
d
d
-
-
B
B
a
a
l
l
a
a
n
n
c
c
e
e
P
P
o
o
l
l
i
i
c
c
y
y
This router supports the function of load balancing. It can assign traffic with protocol type,
IP address for specific host, a subnet of hosts, and port range to be allocated in WAN1 or
WAN2 interface. The user can assign traffic category and force it to go to dedicate network
interface based on the following web page setup. Twenty policies of load-balance are
supported by this router.
Note:
Load-Balance Policy is running only when both WAN1 and WAN2 are activated.
