Section 3 -
Operation
CAUTION:
When operating for the first time, cycle unit down and up several times to confirm satisfactory operation. Be prepared to cut POWER if necessary.
• KEY OPERATED SWITCH
(standard)
-
Two key-operated switches optionally available with this unit:
•
Key-operated power supply switch controls power to flag and switches. When “off”, switches will not operate flag. Key may be removed from switch in either
"on" or "off" position.
•
3-position key switch permits the flag to be operated directly by key. Requires flag operator to have a key.
Section 2 -
Bottom Patriot Panel Installation/Removal
Figure 3
Case as seen from below
Bottom access panel secures to the Motorized Flag
housing with two screws
(one on each end)
, and held in the
closed position by engagement brackets with ball detents
that snap into case support brackets
(Fig. 3)
.
Bottom flange of
Access housing
Bottom Access Panel Door
CAUTION: Beware of pinch points at ends of closure
CENTER of CASE
CENTER
of CASE
Engagement Bracket
With Ball Detent:
will snap into Access
Panel Support Bracket.
Access Panel
Support Bracket
1
2
Attaching Brackets:
Insert pin in top
slot and push up.
Rotate bracket
clockwise to lock
bracket in place.
Remove Screws
from both ends
of Housing.
Access
Panel Door:
Pivot on Hinges.
OPEN
ACCESS
PA
NEL
CLOSED
ACCESS P
ANEL
HOUSING
CAUTION:
The following requires two people to perform safely.
Figure 4
Removing Access Panel
1.
Press up on access panel and pull toward the front of the flag
housing to disengage hinges and remove access panel.
2.
To Remove/Install support brackets:
page 4 of 8
Patriot Motorized Flag
