B
A
SHAFT
HALF
EXTENDED
6.
Install the next coupler
(s)
to
mounting surface.
Final
(Idler-end)
Fabric/Roller Assembly
CAUTION:
The end of the previously-
installed coupler shaft
should be flush with the
outside edge of the bearing.
If coupler shaft extends
beyond the bearing,
retract coupler shaft of the
previously installed roller to
the half extended position.
7.
Lift both ends of the idler-end fabric/roller assembly into
place and align between the brackets.
A
Installer #1 places the idler-end
sliding shaft onto the idler-end.
B
Installer #2 fully extends
coupler shaft of previously
installed roller by rotating the
metal ring clockwise about
½ of a turn when viewing the
face of the coupler assembly
(see "Operating the Retractable
Shaft" and Fig. 2)
, until the shaft
extends fully into the receiver
of the idler-end fabric/roller
assembly.
page 5 of 12
Motorized FlexStyle
TM
(Coupled)
