Draper CHD14V2KIT, Инструкция по эксплуатации

Страница: 5 / 8

- 4 -
TO CHARGE THE BATTERY (Fig 5 & 6)
To charge the battery pack it must first be removed
from the torch. To release the battery pack squeeze
the grips
✭✌
located on either side of the battery
casing and gently pull the battery pack from the
housing (fig.5). Plug the battery charger unit into a
230V/A.C. 13 amp, three-pin socket. Place the
battery in the charger as shown in (fig 6). Do not
force. Ensure the battery is inserted correctly. The
indicator light on the charger will now glow to show
that the battery is charging. When the battery is
fully charged the light will go out (approx. 1 hour).
The battery pack can then be removed and used to
power the tool. To refit the battery pack to the torch
push firmly until the battery pack locates and snaps
into place.
NOTE:
WARNING: Please ensure the Battery Pack
is installed correctly before charging.
CHD142V Plus - CHD182V Plus
OPERATION AND USE cont’d ...
Fig.5.
Fig.6.
Fig.7.
The battery was discharged after manufacturing
and will therefore require five to ten
charges/discharges before it reaches its full
capacity.
BULB REPLACEMENT (Fig.7)
Unscrew the lens
✮✌
anti-clockwise and remove.
The bulb
✯✌
sits in the spring. A spare bulb can
be kept in the holder
✰✌
. When replaced, refit
the lens.
NOTE: Do not cross thread or over tighten the
lens cap.
✭✌
✮✌
✯✌
✰✌
✔ ✖