8.6 ATTACH SUPPORT STAND AND RAISE MIXER
– FIGS. 9 – 12
Note:
The tilt mechanism needs to be locked in position with the chained safety pin
before
attempting to lift the cement mixer.
– Tip the cement mixer over onto it’s face.
– Attach the assembled support stand
into the pivot bracket
.
– Stand in front of mixer, holding the handles raise the mixer, ensure that the support feet do not
slip on surface.
5. HEALTH AND SAFETY INFORMATION
– Ensure familiarity with controls before operating the mixer.
– Replace any worn/damaged safety labelling/information decals.
– Ensure the mixer drum is turning whilst emptying the drum.
– Always ensure the power supply is disconnected before leaving the mixer unattended.
– Do not use the mixer as a wheel barrow.
Warning!
●
Although the safety instructions and operating manuals for our tools contain
extensive instructions of safe working with power tools, every power tool involves a
certain residual risk which can not be completely excluded by safety mechanisms.
Power tools must therefore always be operated with caution!
- 8 -
- 13 -
8. ASSEMBLY
5.4 CONNECTION TO THE POWER SUPPLY
Make sure the power supply information on the cement mixer’s rating plate is compatible with the
power supply you intend to connect it to.
230V Cement Mixer (Stock No’s.01099, 01102)
This cement mixer comes supplied with a UK standard 3 pin plug fitted. It is designed for
connection to a domestic power supply rated at 230V AC.
If an extension lead is required, use an approved and compatible lead rated for this appliance.
Follow all the instruction supplied with the extension lead.
Apart from replacing the fuse in the plug, no other electrical work is recommended on this concrete
mixer.
110V Cement Mixer (Stock No.01100)
This cement mixer should be connected to a 110V power supply using the appropriate 16amp
plug.
FIG.9
FIG.11
FIG.12
FIG.10
CAUTION: Risk of electric shock. Do not open.
This appliance is supplied with a moulded 3 pin mains plug for your safety. The value of the fuse
fitted is marked on the pin face of the plug. Should the fuse need replacing, ensure the substitute
is of the correct rating, approved to BS1362 and ASTA or BS Kite marked.
ASTA
BSI
The fuse cover is removable with a small plain slot screwdriver. Ensure the fuse cover is replaced
before attempting to connect the plug to an electrical outlet. If the cover is missing, a replacement
must be obtained or the plug replaced with a suitable type.
If a replacement plug is to be fitted this must be carried out by a qualified electrician.
The damaged or incomplete plug, when cut from the cable shall be disabled to prevent connection
to a live electrical outlet.
This appliance is Class I† and is designed for connection to a power supply matching that detailed
on the rating label and compatible with the plug fitted.
If an extension lead is required, use an approved and compatible lead rated for this appliance.
Follow all the instruction supplied with the extension lead.
†Earthed : This product requires an earth connection to protect against electric shock from
accessible conductive parts in the event of a failure of the basic insulation.
5.3 RESIDUAL RISK
