11
937.746.4556 |
www.rldrake.com
Installation & Setup
To begin setup, connect the appropriate input and output video cables and plug in the DSE24A power cable.
ETHERNET ACCESS:
Local or remote communication with the unit is only possible through a GUI-based menu via any standard web browser.
Chrome
,
Firefox
and Internet Explorer 7 (or higher) are recommended. Before you can communicate with the unit you
must configure your computer's IP address to conform with your existing IP network or LAN. To do so, follow these steps:
Plug one end of an Ethernet cross cable to the unit’s front-panel RJ45 interface marked
“ETHERNET 1 GIGE”
. Plug the
other end of the cable to your computer.
1.
The following steps explain how to do this for a computer with
Windows 7
,
Windows 8.x
or
Windows 10
operating
software:
a) On your computer, navigate to the "Network and Sharing Center".
(Note: This can be found using the search box in the Start Menu or for Windows 8.x, the Start Screen)
b) Once open, click on “Change Adapter Settings” on left hand side of the window.
c) Right-click on the "Local Area Connection", and then click on the "Properties".
d) A dialog box entitled "Local Area Connection Properties" will appear. In this box, double-click on the
"Internet Protocol Version 4 (TCP/IPv4)".
e) A dialog box entitled "Internet Protocol Version 4 (TCP/IPv4) Properties" will appear. Select the
"Use the following IP address" option and enter the following addresses:
IP address:
172.16.70.2
Subnet mask:
255.255.255.0
No need to enter a value for the
Default Gateway
for local access.
Click
OK
to close the dialog box. Now your computer is ready to communicate with the unit.
- OR -
2. The following steps explain how to do this for a computer with
Windows XP
operating software:
a) On your computer, open the "Control Panel"
b) Double-click on "Network Connections"
c) Right-click on the "Local Area Connection", and then click on the "properties".
d)
A dialog box entitled "Local Area Connection Properties" will appear. In this box, double-click on the "Internet
Protocol (TCP/IP)".
e)
A dialog box entitled "Internet Protocol (TCP/IP) Properties" will appear. Select the "Use the following IP address"
option and enter the following addresses:
IP address:
172.16.70.2
Subnet mask:
255.255.255.0
No need to enter a value for the
Default Gateway
for local access.
Click
OK
to close the dialog box. Now your computer is ready to communicate with the unit.
