DragonWave AirPair 100-UL, Руководство по эксплуатации продукта

Страница: 95 / 130

87 Appendix C – Command Line Interface (CLI)
87
Command Steps
get available frequency Displays the frequency bank. This will show the frequencies for
the direction programmed using the set frequency bank command.
If the frequency bank was selected to GO, then the GO bank of
frequencies is displayed, and similarly the RETURN bank of
frequencies is displayed if the RETURN frequency bank was
selected. .
Sequence:
get available frequency press Enter
The system responds:
(“go” frequencies shown. “return” frequencies will be displayed if the
return bank was programmed).
go Frequencies
Index TX IF RX IF TX RF RX RF
UNL1 670 2000 24080 24150
UNL2 660 1990 24090 24160
UNL3 650 1980 24100 24170
UNL4 640 1970 24110 24180
UNL5 630 1960 24120 24190
UNL6 620 1950 24130 24200
UNL7 610 1940 24140 24210
UNL8 600 1930 24150 24220
Note: All Frequencies in MHz.
get backup ipconfig Displays the backup IP configuration. The system uses the
backup IP configuration if both sides are deleted or made obsolete
by a new software load.
Sequence:
get backup ipconfig press Enter
The system responds (example):
IP Address :192.168.10.100
Subnet Mask :255.255.0.0
Note: These are the factory-set default IP address and subnet mask.
Version 2.0