DragonWave AirPair 100-UL, Руководство по эксплуатации продукта

Страница: 63 / 130

Setting up the SNMP
55
Required Action Steps
6 AutoNeg Mismatched Duplex No
7 LossOfSignalLockFromDemod No
8 BerThresholdExceeded No
9 Mod PLL lock failure No
10 Mod loss of sync bytes No
11 Mod input FIFO overrun/underrun No
12 Mod input data inactivity No
13 SNR below threshold No
14 PLDRO lost lock No
15 Radio lost comm No
16 Radio mismatch No
17 IF Tx Synth Unlocked No
18 IF Rx Synth Unlocked No
set snmp trap [trapIndex]
[enable/disable] Sets the SNMP trap and enables or disables it. DragonWave
recommends enabling the LossOfSignalLockFromDemod trap. This
trap indicates loss of communication with the peer AirPair node.
Sequence:
set snmp trap [trapIndex] [enable/disable] press Enter
The system responds:
Trap# TrapName Enabled(Yes | No)
1 ColdStart No
2 WarmStart No
3 Link down No
4 Link up No
5 Explicit Authentication Failure No
6 AutoNeg Mismatched Duplex No
7 LossOfSignalLockFromDemod No
8 BerThresholdExceeded No
9 Mod PLL lock failure No
10 Mod loss of sync bytes No
11 Mod input FIFO overrun/underrun No
12 Mod input data inactivity No
13 SNR below threshold No
14 PLDRO lost lock No
15 Radio lost comm No
16 Radio mismatch No
17 IF Tx Synth Unlocked No
18 IF Rx Synth Unlocked No
save mib Saves the MIB to FLASH. Perform this command to save setting
changes to FLASH. This command does not restart the system and
does not put any new settings into effect.
Version 2.0