Dräger D-Vapor, Инструкция по эксплуатации

Страница: 39 / 120

Instructions for use D-Vapor/D-Vapor 3000
39
Preparation
Connecting the power cable
Only use the correct power cable.
1 Lay the vaporizer on its side.
2 Plug the IEC connector (A) into the socket.
3 Lay the cable in a loop around the strain relief
post (B).
4 Insert the cable bushing (C) with the cable into
the casing.
5 Refit the baseplate.
Before first operation and after
disconnection from mains power supply
for an extended time
1 Connect the vaporizer to mains power supply
for 1 hour. The battery will be charged.
2 Set control dial to the T position.
3 Fill the vaporizer, see page 42.
4 Check operational readiness, see page 54.
5 Check the concentration, see page 57.
Fitting the connectors

Always connect the vaporizer in such a way that
the gas flows as shown in the diagram and
matches the arrow on the rear of the vaporizer.
 Observe instructions for use of the anesthesia
workstation.
017
B
C
A
WARNING
Risk of incorrect output concentration or es-
cape of anesthetic agent
Connectors may only be fitted by specialized
service personnel as the connectors must be
dismantled and checked.
Use only authentic Dräger parts. Otherwise,
the correct functioning of the medical device
may be compromised.
Only selected materials may be used with an-
esthetic agents.
018
WARNING
Risk of patient injury
If the flow is in the wrong direction, an incor-
rect concentration may be delivered, often an
increased concentration.
Outlet
Inlet