DR Whisper Lite CEM1000, Руководство по безопасности и эксплуатации

Страница: 9 / 24

DR
®
WHISPER LITE
®
CORDLESS Electric Mower Safety & Operating Instructions 3
(
How to Set Up Your Lawn Mower—continued
)
Note: The mower will not operate without the discharge chute or the mulching cover installed
because of the magnet built into each ( Figures 5 and 6 ). Make sure the magnet is clean and
free of debris. Also, make sure these covers are always firmly screwed down on the machine,
or the lawn mower will not operate.
Important: Make sure your battery is fully charged before operating your mower. Refer to the
charging instructions on page 4.
Operating Instructions
Pre-Start Checks
Þ
Check to make sure the mulching cover or side discharge chute is in its proper place and securely
tightened. The mower will not operate unless the mulching cover or side discharge chute is
installed.
Þ
Check the external surfaces of the mower and remove any accumulation of dirt, dust or dried
grass clippings.
Þ
Cut 1" to 2" of grass at a time. Check the cutting height and readjust to the desired height before
starting the lawn mower. Use a greater height for cutting tall grass. Refer to Cutting Height
Adjustment on page 6 for instructions.
Note: The lawn mower battery pack has been fully charged at the factory. However, since
batteries self-discharge over time, you must recharge the battery pack to a full charge
before using your mower for the first time
.
✦
Reminder: To reduce the risk of injury, the mower will not run unless the discharge chute or
the mulching cover is installed. The magnet on the discharge chute or the mulching cover
must have clean contact with the mower.
✦
Reminder: The length of time that a battery can hold its charge while mowing a lawn depends
upon lawn conditions; tall, thick, or wet grass make the mower work harder and cause the
battery to discharge faster.
Figure 5 Figure 6
Magnet
in chute
Close-up of magnet in the discharge chute.
A magnet is also in the mulching cover.