CONTACT US AT
www.DRpower.com
9
Upper
Handlebar
Figure 5
Lower
Handlebar
Cable
Rotary
Knob
Guide Pin
Carriage
Bolt
Nut
Assembling the Handlebar Assembly
1.
Position the Mower Assembly on a flat clean surface.
2.
Move the Upper Handlebar Assembly off to the side (
Figure 5
). Ensure that
the Cable is positioned away from the Lower Handlebar mounting area.
3.
Position the Lower Handlebar onto the Mower Brackets with the Mower
Guide Pins into the Holes of the Lower Handlebar (see detail).
4.
Secure both sides of the Handlebar with the Carriage Bolt (on the inside)
and the Nut and Rotary Knob (on the outside).
Note:
Ensure that the Carriage Bolt square under the head fits fully into the square
in the Handlebar.
5.
Position the Upper Handlebar onto the Lower Handlebar and align the holes
(
Figure 6
).
6.
Insert the threaded stud of the Wrench Handle through the holes and screw
it clockwise into the Nut that is inside the Bracket.
7.
Fold the Wrench handle down against the Handlebar (
Figure 7
). If the
Wrench Handle is loose, open it again and rotate clockwise until it is snug
when folded down.
Note:
The Wrench Handle should be snug, but if it takes too much effort to fold it
down it could damage the Wrench handle. Turn counter clockwise to loosen
if needed.
8.
Secure the Cable to the Upper and Lower Handlebars using the Wire Clamps
supplied.
Installing the Battery
1.
Open the Battery Cover and insert the Battery into the Mower (
Figure 8
).
Ensure the Battery is pushed in completely so the Latch locks it in place.
2.
Ensure that the Safety Key is inserted into the Key Slot.
Battery
Figure 8
Safety
Key
Latch
Wire
Clamp
Figure 7
Wrench
Handle
Cable
Lower
Handlebar
Figure 6
Upper
Handlebar
Cable
Wrench
Handle
Nut and
Bracket
Washer
