DR PRO-16, Руководство по безопасности и эксплуатации

Страница: 10 / 20

10
DR ®
PRO-16 Battery Lawn Mower
Chapter 3: Operating the DR PRO-16 Battery Lawn Mower
It may be helpful to better familiarize yourself with the features of your Mower by reviewing Figure 2 in Chapter 2 before beginning
the steps outlined in this chapter.
Adjusting the Cutting Height
Use the Height Adjustment Handle to set all four Wheels to the same cutting
height as desired (
Figure 9 ). Pull Lever outward, move Lever to desired position,
and release Lever to lock in notch.
Notch Position Cutting Height
1st: Fully towards rear of mower
1.0 inch (2.5 cm)
2nd: 1.4 inch (3.6 cm)
3rd: 1.8 inch (4.6 cm)
4th: 2.2 inch (5.6 cm)
5th: 2.6 inch (6.6 cm)
6th: Fully towards front of mower 3.0 inch (7.6 cm)
Bagger Setup
The Bagger can be installed to capture clippings for dumping at a designated
location. The Mulcher Plug needs to be removed to direct clippings into the
Bagger.
1. Hold the Rear Cover in the upright position (
Figure 10
).
Note: If you are installing the Bagger Assembly prior to operation, remove the
Mulching plug shipped in the rear of the machine (
Figure 11
).
Rear Cover
Figure 10
Height
Adjustment
Handle
Figure 9
Height
Locking
Notches
Lower
Higher
2
1
Adjusting the cutting height may bring you into contact with the mowing
blade, causing serious injury.
•
Stop the Motor and remove the Safety Key.
•
Do not put your fingers under the housing when adjusting the cutting
height.
Read and understand all warnings listed in “Chapter 2 General Safety Rules” before operating this Mower.
Mulching
Plug
Figure 11