DR PREMIER RAPIDFIRE, Руководство по безопасности и эксплуатации

Страница: 21 / 32

CONTACT US AT
www.DRpower.com
21
The Handle Yoke must move just past center as it contacts the Bolt Stop. If it is at the center position, or off center in the wrong
direction, the force of splitting a log will be transferred through the Engagement Handle and could cause injury.
7. Push the Engagement Handle all the way forward to confirm the Steel Bushing Yoke is moving just past center.
When using the Splitter for the first time after this adjustment, split smaller diameter logs with no knots to verify that the
adjustments are correct before trying larger diameter tougher logs.
If you have any questions please contact us at www.DRpower.com or call 1-800-DR-OWNER (376-9637) for assistance.
Replacing the Wheels
Tools and Supplies needed:

Pliers

Jack and Jack Stands
1. Jack the Splitter off the ground and secure with Jack Stands.
2. Straighten the ends of the Cotter Pin with Pliers so the Cotter Pin can be
pulled from the hole in the Axle (
Figure 42 ).
3. Pull the Wheel assembly from The Axle.
4. Install the new/repaired Wheel Assembly and secure with a new Cotter Pin
by bending the ends of the Cotter Pin with Pliers.
Cotter Pin
Figure 42
The Splitter must be supported carefully so it does not tip over when jacking
or it could cause Splitter damage or personal injury.