DR PREMIER RAPIDFIRE, Руководство по безопасности и эксплуатации

Страница: 11 / 32

CONTACT US AT
www.DRpower.com
11
5. Install the Tray Bracket to the Frame Stand with four Carriage Bolts and
Locknuts using two 9/16" Wrenches (
Figure 10 ).
6. Install the Frame Stand onto the Tray with four Bolts, Flat Washers and
Locknuts (
Figure 11 ).
Adding Oil and Gasoline (gas engine model)
Engine Oil See Engine Manual for specific Engine capacities and
specifications
Fuel Unleaded gasoline
NOTE: Use only the recommended high detergent engine oil. Other types of oil
could cause problems operating your machine. Please refer to your Engine
Owner’s Manual for detailed oil information.
Supplies Needed:

Clean Rag

Engine Oil
1. Position the machine so the Engine is level. Remove the Oil Fill/Dipstick
(
Figure 12 ) and clean the end of it with a rag.
2. Machines are shipped with no oil . Initially add approx, 8 oz. of the oil
recommended by the Engine Manufacturer. Wait one minute for the oil to
settle.
3. Replace the Dipstick, but DO NOT screw it in to ensure an accurate reading
and then remove it to check the oil level (clean the Dipstick with the clean rag
after checking).
4. Continue adding a few ounces of oil at a time, rechecking the Dipstick until
the oil reaches the fill mark. Be careful not to overfill.
5. Replace the Dipstick and screw all the way down when full.
Oil Dipstick
Figure 12
The Engine must be level to get an accurate reading when adjusting the
amount of oil. If the machine is not level, the oil level reading will not be
accurate and may cause engine damage.
Frame
Stand
Figure 10
Tray Bracket
Carriage Bolts
and Locknuts
Support Leg with
Tray Bracket
Figure 11
Bolt, Flat Washer
and Locknut