10
DR
®
9.5 Chipper Shredder
Figure 9
Shredder
Hopper
5/16-18 Flange
Locknuts
Flywheel Housing
Bracket
Figure 11
Shredder Guard
and Bracket
Assembly
1/4-20
Locknuts
Shredder
Hopper
5/16-18
Flange
Locknuts
Flywheel Housing
Bracket
3.
Position the Hammermill Housing/Shredder Hopper Assembly onto the
seven studs of the Flywheel Housing (
Figure 8
). The two studs at the back
of the Shredder Hopper will go through slots in the Flywheel Housing
Bracket (
Figure 9
).
4.
Check the fit between the Hammermill Housing Flange to the Flywheel
Housing (
Figure 8
). If there are any noticeable gaps, continue to step 5. If
there are no noticeable gaps, go to step 6.
5.
Remove the Hammermill Housing/Shredder Hopper Assembly, loosen the
hardware installed in step 2 and adjust the Hammermill Housing and
Shredder Hopper to align better with the Flywheel Housing.
Retighten the
hardware and return to step 3
.
6.
Manual Start Model
- Secure the Hammermill Housing/Shredder Hopper
Assembly with nine (seven in front and two in back) 5/16-18 Flange
Locknuts using a 1/2" Wrench (
Figure 8 and 9
).
Electric Start Model
–
Note:
When installing the Hammermill Housing for the Electric Start
model, do not install the two Locknuts where the Leg will be attached
(
Figure 10
) until the machine can be tipped back and supported as
described.
Secure the Hammermill Housing/Shredder Hopper Assembly with seven
(five in front and two in back) 5/16-18 Flange Locknuts using a 1/2"
Wrench (
Figure 8 and 9
).
Tip the machine back and support the Shredder Hopper with a Jack Stand
under the Hopper (
Figure 10
).
Position the Leg onto the lower portion of the Hammermill Housing and
secure the Leg with two 5/16-18 Flange Locknuts using a 1/2" Wrench.
7.
Install the Shredder Hopper Guard and Bracket Assembly with three 1/4-20
Flange Locknuts using a 7/16" Wrench (
Figure 11
).
Leg
Figure 10
Hammermill
Housing
Figure 8
5/16-18
Flange
Locknuts
Flywheel
Housing
Hammermill
Housing
Flange
