14
Quick Start: How to Connect to the Cell2 Interface
7
Most users find it easiest to give the unit an IP address, subnet and gateway through the front craft port (TTY
interface) to start. Once these settings are saved and you reboot the unit, you can access it over LAN to do the rest
of your databasing via the Web Browser interface.
Alternative option:
You can skip the TTY interface by using a LAN crossover cable directly from your PC to the
Cell2 Interface and access its Web Browser. See Section
Cell2 Interface Web Browser
.
...via Craft Port
7.1
1. The simplest way to connect to the Cell2 Interface is over a physical cable connection between
your PC's USB port and the unit's USB craft port.
Note:
You must be connected via craft port or
Telnet to use the TTY interface. Make sure you are using a standard A-B USB cable (this same
cable is commonly used for USB printers) to make a USB craft port connection. We'll be using
HyperTerminal to connect to the unit in the following example - however, most terminal-emulating
programs are also compatible.
Note
: The following images display the setup process done in Windows XP.
The following steps will occur the first time any DPS USB equipment is used on this PC. If you've
used a different DPS USB device before and have installed the DPS USB drivers, then
skip to Step
9
.
When you first connect the Cell2 Interface to your PC via USB, a "Found New Hardware" message
will appear:
1. Click the "Found New Hardware" message/icon to launch the "Found New Hardware Wizard".
Содержание D-PK-SMSBX-12021
Страница 12: ...8 Cell2 Interface Back Panel 6 Cell2 Interface back panel connections...
Страница 48: ...44 Stats 12 4...