Dovre 94992, Инструкция по эксплуатации

Страница: 20 / 26

20
Use
Check that all the screws and nuts are
tightened securely and that there are no
defective or worn parts on the concrete
mixer.
Place the concrete mixer in its intended
location and plug it in.
Tilting the drum
Hold on to the turning handle tightly and
tip it over. Turn the drum to the required
position and release the handle again so
that it engages in the adjusting disc.
Mixing
Tilt the drum to a position that will prevent
the mixture from unintentionally running
out of the drum.
Start the concrete mixer using the on/off
switch.
Add water and base materials, such as sand
or gravel.
Fill with binder. Use the mixture recipe best
suited to the purpose. If necessary, consult
an expert
Allow the drum to rotate until the mixture
reaches the required consistency.
Emptying
Place a builder’s wheelbarrow or similar
under the drum opening.
Hold on to the turning handle tightly and
pull it out. Allow the rotating drum to slowly
tilt downwards so that the mixture pours
into the wheelbarrow.
Safety devices
The concrete mixer is equipped with a
safety device that automatically turns
the concrete mixer off in the event of
a power failure so that it does not start
unintentionally once the power returns. If
there has been a power failure, you can turn
the mixer back on again using the on/off
button.
Cleaning and maintenance
Unplug the mixer. Clean the drum inside
using a scraper and steel brush. Rinse
afterwards with a hose. If you get concrete
on the gear rim, it should be removed
immediately.
Make sure that no water gets into the motor
housing, its vents or the on/off button.
Store the concrete mixer inside in a well-
ventilated location.