5
Initial Setup
The spray attachment is in the accessory box.
Attach it to the discharge hose.
Remove the black cap from the water fi ll port
(it rotates COUNTER CLOCKWISE to open).
Fill the tank with cool, clear tap water. See
Fig. D.
To connect the chemicals, remove the ship-
ping cap and the seal on your chemical bottle
and discard. Place the strainer and weight
into chemical bottle and screw the chemical
feed line cap on to bottle. See Fig.E.
1.
2.
3.
Prime the Unit
Set the nozzle on the spray attachment to “S”.
See Fig. F.
Set the chemical select valve to either of the
products (lower two positions on select valve).
See Fig. G.
Plug unit into 120 VAC Outlet.
Press and release the reset button.
Verify the red band at the base of the reset
button is not visible.
Press the test button.
Verify that the red band on the rest button ap-
pears.
Press and release the reset button.
Turn the power switch on. The pump should run
for a short time, then stop. (The pump will run
until the discharge pressure reaches the factory set
point. The pump will then turn off until the trig-
ger on the spray attachment is activated.)
Direct the spray nozzle into a drain or other con-
tainer and pull the trigger.
Run until a steady spray pattern is established,
1.
2.
3.
a.
b.
c.
d.
e.
4.
5.
6.
Water fi ll port
Fig. D
weight
strainer
Fig. E
chemical feedline
cap
S
Rollover Valve
Spray attachment
R
Fig. F
Illuminated Power Switch
Fig. G
Fuse Holder
Rinse
Settings
Chemical “A”
Chemical “B”
Chemical “B”
Chemical “A”
without air in the water stream.
Release the trigger. The pump should stop almost
immediately. If it does not, operate the unit longer
as it is not fully primed.
7.
Turn the selector to the other product and repeat.
8.
1.
