Dover HYDRO AquaBlend Xtreme, Руководство пользователя

Страница: 6 / 15

6
1.OO overview (continued)
1.O4 Safety Precautions & Warranty Compliance
WARNING! Please read precautions thoroughly before operation. Must meet all applicable local codes and regulations.
Remove Red Caps Prior to Installation
Your injector is 100% factory tested before delivery and
may contain a small amount of water. The three red plastic
caps are fitted after testing to ensure cleanliness of
the injector.
Before Applying Aggressive Chemicals
Please consult your distributor, chemical manufacturer
or contact Hydro Systems customer service to confirm
compatibility with your injector. Always wear proper safety
protection as recommended by chemical supplier.
Label all Fluid Lines, Valves and Connections
If the solution that is being injected is not suitable for
drinking, all fluid lines should be labelled, "Warning: Not for
human consumption!"
Monitor Outlet Flow
It is the user's responsibility to monitor the output of
chemical injected.
A Filter is Recommended and Required
Install a filter of 140 mesh (104 micron) or finer depending
on your fluid quality to prolong the working life of the
injector and for the warranty to be valid. A filter is imperative
since most fluid contains impurities or particles, especially if
the fluid source comes from a well, pond or lake.
Avoid a Potentially Hazardous Chemical Accident
Select a safe location. Chemical container should be kept
away from children and/or high usage areas and the location
must also not be susceptible to freezing temperatures.
Avoid Solution Contamination
Use only clean FILTERED fluid. Do not allow contaminants
to enter the solution container. Dirt, debris and other
contaminants in the solution container may cause excessive
wear to the unit.
Fluid Temperature
Min: 34° F (1°C) Max: 100° F (38°C)
Maximum Fluid Pressure 90 psi (6,2 bar)
Install a pressure regulator and/or pressure relief valve
to ensure operating pressure does not exceed the
maximum specification.
Before Removing An Injector From The System
Release fluid pressure. While the system is in operation, turn
off the incoming fluid valve. Leave the out going valve open
this will relieve the pressure at the injector and all parts of the
system after the injector. Injector is now safe to remove.
1.O5 General Tips
For A Long Service Life
Start with clean fluid by using an inline filter to reduce
impurities. Keep the solution container covered and clean.
Keep the suction tube filter 2" (5 cm) from the bottom of the
container. Perform maintenance procedures as
recommended (see Maintenance page 9).
Soluble Powder Use
Ensure the chemical is completely dissolved before starting
the injector. If necessary, dissolve the chemical in hot
water and allow to cool before using. Failure to thoroughly
dissolve the chemical will cause premature wear to the
dosage piston/gasket and the inner cylinder.
Please read this instruction manual thoroughly. Following the procedures, will increase the life of your injector.
Keep From Extreme Temperature
Protect the injector from freezing temperatures or
excessive heat.
Rinse Injector After Each Use
Additive allowed to remain in injector can dry out, foul or
damage the lower end at the next start-up (see Maintenance
page 9).
Injector Not in Use for an Extended Period
If the injector has not been stored properly deposits may
have dried onto the motor (see Maintenance page 9). Before
operation, soak entire unit into room temperature water
approx.. 72° F (22° C) for a 24 hour period.