Dover Hillphoenix ONRZ, Руководство по установке и эксплуатации

Страница: 6 / 39

4
1
4
3
5
2
Fig. 3 Bolt holes, foam tape gasket and sealant
= bolt holes
– = foam tape gasket
O = butyl or silicone sealant
NOTE: It is recommended that
cases be bolted together in
the numbered order indicated
in the diagram.
6
7.
Push the cases tightly together, then lightly bolt them
together through the holes that are provided (Fig. 3).
Tighten all the joining bolts until all margins are equal.
Be careful not to over tighten.
8.
Repeat steps 2-6 of this sequence for all remaining
cases. Be certain to properly level all cases.
9.
If seismic brackets were ordered, see Appendix J for
detailed installation instructions.
CASE INSTALLATION
Fig. 6 Streamlyne master bumpers and joint trim
STREAMLYNE
MASTER
BUMPER
EXTERNAL
BUMPER
JOINT
TRIM OUT
1.
To align the master bumpers, install the master bumper
joint trim in between adjoining master bumpers. (Fig.
4). Slide the master bumpers left or right to close the
seams as required, working outwards from the center
of the line-up to the ends.
2.
Close the seam where the bumper joins the case end.
The bumper joint closes the seam that may develop
if the master bumper is moved away from the end to
close the case-to-case joint seam.
3.
Seal the interior case-to-case joints with caulk (sup-
plied), then apply acrylic tape (supplied) over the pipe-
chase seam (Fig. 5). The tape acts as a watershed pre-
venting water from settling in the case joint.
4.
If the case has a Streamlyne bumper (Fig. 6), the bum-
per will be shipped loose in the case. Before install-
Fig. 4 Master bumper and joint trim
MASTER
BUMPER
MASTER
BUMPER
JOINT TRIM
Fig. 5 Sealing the pipe chase
ACRYLIC
TAPE
PIPE
CHASE