Dover GROEN NHFP, Руководство оператора

Страница: 8 / 24

OM-NHFP
OM-NHFP
8
(2) Set the thermostat to "OFF".
(3) Depress the knob on the
Combination Control and turn it
clockwise to "OFF".
(4) Wait 5 minutes, then proceed as
instructed at "To Start Pan"
above.
2. For Model NHFP(E) with Hot Surface
Igniter
a. To Start Pan
(1) DO NOT attempt to light the
burner with a flame.
(2) Turn on the electrical service to
the unit.
(3) Turn the main supply gas cock
ON (handle parallel to the gas
pipe).
(4) Turn the thermostat dial to the
desired temperature setting.
b. To Turn Off Pan
(1) Set the thermostat to "OFF".
(2) For a prolonged shut-off period:
(a) Set the thermostat to "OFF".
(b) Turn the main gas cock OFF
(handle at right angles to the gas pipe).
(c) Disconnect the electrical
power from the unit.
WARNING
WHEN TILTING BRAISING PAN FOR
PRODUCT TRANSFER:
1) WEAR PROTECTIVE OVEN MITT
AND PROTECTIVE APRON.
2) USE CONTAINERS DEEP ENOUGH
TO CONTAIN AND MINIMIZE
PRODUCT SPLASHING
3) PLACE CONTAINER ON A STABLE,
FLAT SURFACE, AS CLOSE TO THE
BRAISING PAN AS POSSIBLE.
4) STAND TO THE SIDE OF THE PAN
WHILE POURING — NOT DIRECTLY
IN THE POUR PATH OF HOT
CONTENTS.
5) RETURN PAN BODY TO UPRIGHT
POSITION AFTER CONTAINER IS
FILLED OR TRANSFER IS
COMPLETE.
6) DO NOT OVERFILL CONTAINER.
AVOID DIRECT SKIN CONTACT
WITH HOT CONTAINER AND
CONTENTS
3. To Tilt Either Model
a. Press the power tilt switch down to
raise the pan or up to lower the pan.
b. The spring loaded switch will return
to the OFF (middle) position when
you release it.
c. If the power tilt mechanism stops
working (see the Troubleshooting
section) and you must raise or lower
the pan body without delay, you can
tilt the body by hand. Fit the provided
hand crank onto the slotted shaft end
that sticks out of the actuator motor
(the end facing the front of the unit).
Turn the crank clockwise to lower the
pan or counterclockwise to raise the
pan. It may take several minutes to
crank the pan to the desired position,
but the operation can be speeded up
by substituting a reversible electric
drill with screwdriver bit in place of
the hand crank.