Douglas Dynamics WESTERN ENFORCER 94040-3, Руководство по установке

Страница: 14 / 18

Lit. No. 74914, Rev. 01 14 June 1, 2020
OPERATIONAL TEST AND FINAL ADJUSTMENTS
CENTER CUTTING EDGES
The center cutting edge spacer plate is located on the
T‑frame below the pivot pin hinges.
1. With the blade wings in the retracted (vee)
position, the center cutting edges should touch
the center cutting edge spacer plate. If they do not
touch the spacer plate, adjust the center cutting
edges as follows.
2. Loosen the four 5/8" x 2" center cutting edge
carriage bolts, but do not remove them.
3. Slide the center cutting edges inward until they
contact the spacer plate.
4. Re‑tighten the center cutting edge carriage bolts
according to the torque chart.
5/8" x 2"
Carriage Bolts
Spacer Plate
Center Cutting Edge
Lubricating the Pivot Pin Hinge
Using a rubber-tipped seal-off coupler tip, apply a
good quality multipurpose grease at the five grease
points along the center pivot pin hinge.
Grease
Points