Douglas Dynamics 77700, Руководство по установке

Страница: 9 / 14

Lit. No. 52524, Rev. 05 9 July 15, 2020
INSTALLATION INSTRUCTIONS
HEIGHT ADJUSTMENT AND
A‑FRAME BLOCKING
1. Park the truck on a flat, level surface. Install
the receivers into the truck mount pockets and
measure the distance from the ground to the
bottom edge of the receiver (height "X" below).
2. Position a floor jack under the rear of the
headgear (see below).
3. While depressing the stand, move the
attach/detach lever backward into the "detach"
position to lock the stand into the off-truck
position. Using a floor jack, raise the headgear
so that the bottom of the hitch pin notch is at the
same height as the bottom edge of the receiver
(height "X").
4. Verify that the stand actuator pin is on top of the
stand.
5. Block the A‑frame so that the jack can be safely
removed while maintaining the correct height.
6. Attach the snowplow to the vehicle, following the
instructions on the Attach/Detach label located on
the back of the blade.
Ground
Place floor jack
below headgear.
Headgear Slot
Bottom Edge
of Receiver
X
X
Headgear