Lit. No. 77341, Rev. 01
5
April 1, 2020
33230
2. Remove the exhaust de
fl
ector; save for
reinstallation.
3. Place 1/2" washers on two M14 x 40 mm cap
screws. Place the left hanger against the front of
the vehicle and install the cap screws through the
locations shown. Tighten the fasteners hand tight.
INSTALLATION INSTRUCTIONS
NOTE: For easier assembly and installation, the
vehicle and all snowplow components should be
on a smooth, level, hard surface, such as concrete.
1. Detach the loader from the vehicle, if equipped, then
remove the brush guard. Save the brush guard and
fasteners for reinstallation if the mount is removed.
Remove the
exhaust de
fl
ector.
Left Hanger
M14 x 40 mm
Cap Screws
with 1/2" Washers
Detach the loader.
Remove the brush guard.
