Page 7
Treadmill Common Error Messages
Prompt Description
Code
E1
Fault description
Troubleshooting
After turning on the power, the
communication between the monitor
and the lower control line is abnormal.
The monitor displays the fault code,
and the buzzer sounds 3 times.
Possible cause: The communication
between the electronic control system
and the monitor is blocked.Check
whether the circuit connecting the
electronic meter is intact.If it is
damaged, replace the connecting wire.
E2
The voltage on the motor is not
detected by the controller
1. Confirm whether the motor cable has
been connected well.
2.Confirm whether the sensor plug is
not plugged well or damaged, plug it or
replace it.
3.If the motor was damaged, replace
the motor.
E3
E5
No speed sensor signal
Overcurrent protection
Confirm whether the motor cable is
connected correctly, if not, please
reconnect the motor cable. Confirm
whether the controller any smells, if
yes, please replace the controller.
If the load exceed the current limit,
there is a protective system. If a part of
the treadmill is stuck, the system is
under heavy load, the system will
product himself, please check the
current and voltage to solve the stuck
problem.
E6
Explosion protection
Confirm whether the voltage is under
50% of the normal voltage. If yes,
please re-test with the right voltage to
make sure the controller and motor
wires are normal.
