Safety
Safety instructions
In order to protect the exposed connection cable from rodents it should be protected against mar-
tens (see installation accessories).
High ambient temperatures shorten the life of the LED‘s. Ensure a good heat dissipation in order to
guarantee a long life of the LED. During operation, do not expose the spot to ambient temperatures
of > 45°C. Do not cover the spot, provide free air circulation.
Do not open the housing of the luminary. The tightness of the
clarios eco
is only guaranteed if also
the outer sheath of the connection cable is undamaged and if the connection cable is bonded in a
waterproof way. Otherwise, because of the capillary effect, the penetrating moisture can reach and
destroy the electronics of the spot.
Assembly
Preparation
Depending on the configuration, unpack all the parts included in the scope of delivery and check
them for completeness and intactness.
Dispose of the packaging material no longer needed in accordance with applicable regulations.
If you notice any damage from transport, immediately contact the dealer where you purchased the
luminary.
Mechanical installation
Mark the hole for substrate mounting through a hole in base of the mounting bracket. The dowel in-
cluded in the scope of delivery is suitable for installation in concrete, stone and masonry. Drill a hole
of Ø 8 mm and deeper than 50 mm into the substrate and insert the dowel into the hole. In case
of wooden substrates the mounting bracket can directly fixed using the supplied screw, without the
dowel. In case of hardwood the holes may require pre-drilling with Ø 3 mm.
Position the mounting bracket over the dowel, orientate it into the desired direction and screw it
down with the supplied screw.
Now, the
clarios eco
can be attached to the mounting bracket.
1.
Thread a spring ring onto a screw, insert it through a hole at the upper end of the mounting
bracket, thread a plastic washer onto the screw and screw it laterally into the threaded holes on
the luminary housing. In order to do so, insert the spot in the mounting bracket.
2.
Repeat that with the second screw, spring ring and plastic washer on the other side.
3.
Pay attention to correct sorting: screw head, spring ring, mounting bracket, plastic washer, lumi-
nary housing.
4.
Orientate the spot in the desired direction and screw it tight with a 4 mm hex key.
19
en
