DOSKO 2961010CE, Руководство пользователя

Страница: 11 / 36

Operation (cont’d)
11
3. Wear long pants to protect legs from sparks, hot engine and flying
debris.
4. Never wear jewelry or loose-fitting clothing when starting or
operating the grinder or any mechanical device.
Loose or dangling
apparel, jewelry or hair can become entangled in moving parts.
Trim Stump with
Saw Cut or trim the stump preferably to ground level using a power saw.
Clear Area
Dig away the earth and remove any stones near the tree stump or roots that
may interfere with your work.
Work During
Daylight Hours Only use the machine in daylight or in well-lit conditions. Never operate
the grinder after dark. Never operate the grinder in icy conditions or when
there is severe weather.
Battery Installation
Your stump grinder’s engine is equipped with an electric starter (depending on model), which
requires the installation of a 12-volt lawn tractor size battery (Group U1). See the Engine owner’s
manual for battery rating.
The battery is to be supplied by the customer and should be installed in the protective battery box
located near the engine. (The inside dimensions of the battery box are 22.5 cm L x 15 cm W x 21.5
cm H.) Follow the instructions detailed below for connecting and disconnecting the battery.
WARNING: Battery Hazards

Batteries are hazardous because they contain caustic acid, can emit explosive gases and can cause
electric shock. Caution must be exercised when making connections to a battery to avoid shock and
contact with the acid, and to prevent any sparking that could lead to an explosion.

ALWAYS follow the general battery safety rules and instructions listed below.
General Battery
Safety Rules

ALWAYS use eye protection when handling batteries.

NEVER smoke or work near sparks or other sources of ignition.

NEVER touch both battery terminals at the same time with your hand or
any non-insulated tools.

If battery acid contacts skin or clothing, flush immediately with water and
neutralize with baking soda.
Connecting the
Battery
Always connect the cables in the following sequence to avoid possible shock:
1. Find the battery cables located inside the battery box.
2. Connect the
red cable to the positive (+) terminal of the battery.
3. Then connect the black cable to the negative (-) terminal of the battery.