4
For these steps you will need the PRV, PRV Bracket, PRV Adapter Kit from your Micro-Doser Kit & the
*Etatron eOne MF Pump
Attach the
PRV Bracket
to the bottom of the
PRV
.
Use the nut and washer (included) to ensure the
bracket is on securely.
NOTE:
The outer holes on the bracket are used for
mounting the PRV to a surface. Those need to be
drilled out to accommodate ¼” screws/bolts.
Place the
Small O-rings
in the grooves of the
Adapter
, and the
Large O-rings
in the threads of
the
Adapters
.
NOTE:
Wrap thread tape around the adapter’s
threads 2 - 3 times to avoid any leaks.
Attach the
Adapters
to the
PRV
by threading them
into the
Unions
. Make sure the large
O-rings
face
the
Unions.
Do not overtighten.
Take your pump from its box and mount it on the
wall using the bracket included with the pump. Grab
the Opaque Rigid Polyethylene Discharge Tube
(
ORPDT
) included with the pump, and cut it in half
(if cut too short the tension may cause leaks).
Connect each one of the tube’s halves to the
Adapters
on the
PRV
(see step 16).
To attach the tubes to the
PRV
, insert the tube
through the outside opening of
PRV Nut
. Insert the
Locking Collar
making sure the
Collar’s
crown
points away from the
Nut
. Now, insert the
Nozzle
in the tube’s opening. Push the
Collar
and
Nozzle
together as close as possible. Repeat for the other
tube half.
Now attach the ORPDT to the
Adapters
on the
PRV
using the
Nuts.
12
13
14
15
16
17
Assembly & Connection of the PRV
to the Etatron Pump
O-rings in place
*Etatron pump not included in the kit.
(
ORPDT
)
Opaque Rigid
Polyethylene
Discharge Tube
flow
