Fig. 2: Assembly
2. Tighten screw (1) using a hexagon socket
screwdriver.
3. Slide the spray gun with the bore of the
fastening bolt (2) onto the fastening
device.
4. Tighten screw (1) using a hexagon socket
screwdriver.
5. Loosen locknut (3).
6. Set orientation angle on the housing
(1)by using angular gauge.
Alignment is not important.
Distance to the work piece:
15 to 25 cm.
7. Tighten the locknut (3).
8.
WARNING!
Statically charges components may
cause explosions during operation!
Ground the spray gun through the fas-
tening bore or material connection lines, if
the fastening device itself is non-conduc-
tive or is not grounded. Ensure housing
contract.
In the following cases, pro-
vide an additional voltage
equalizing cable between
spray gun and pressure
device (minimum cross sec-
tion: 4 mm):
– When processing easily
flammable materials with
ignition temperature
lower than 21 °C
– When processing mate-
rials that heat up beyond
their ignition temperature
due to the processing
Resistance between housing and
grounding terminal
≤
1 M
Ω
.
Assembly
01/2017
EcoGun AL AUTO - MSG00012EN
8/40
