Guangdong Dorosin Electric Appliance Co.,Ltd.
7
Notices!
1. If the set humidity is higher than the actual humidity, the dehumidifier stops working;
2. During dehumidification, after the compressor starts working, the fan and compressor
can only be stopped after working for at least 3 minutes; the compressor can only be
re-started 3 minutes after stops; After about 72 hours of continuous operation, the
compressor will be stopped and resumed 30 minutes later;
3. If works under low temperature, the dehumidifier may judge the system temperature
automatically and defrosts automatically; when defrosting, the indicator of defrosting is
light, the fan works and compressor stops working.
4. The system has auto memory. When all the mode setting has been finished, if there is
sudden power cut during operation, or the power jack slips out, the system may store the
current status before the power is cut and enter the operation before power cut
automatically after power is supplied;
5. Range for humidity is 10%-99%;
6. If the dehumidifier is going to be spared for a long time, please unload the power cord or
cut the power.
7. Auto detection of temperature/humidity failure.
a. When the system detects that temperature sensor exceeds the limited range, the
system enters mode of temperature sensor failure. Under this mode, LCD displays
temperature failure code “E1”, the system works in a circle of dehumidification for 30
minutes and defrosting for 15 minutes;
b. When the system detects that humidity sensor exceeds the limited range, the system
enters mode of humidity sensor failure. Under this mode, LCD displays humidity
failure code
“
E2
”
and the system starts continuous dehumidification.
c. After temperature/humidity sensor failure being removed, the system works normally.
Chapter 4. Troubleshooting
Problems
Phenomenon/Reason
Solutions
Dehumidifier does not
work.
1.Could be a power outage.
2. The power switch is not on.
3.Maybe the fuse has blown out.
4.It’s not the definite starting up time.
5.The water tank may be full or not
fixed well
，
and the light of full water
on screen is flashing.
1.Please wait for power supply.
2. Turn on the power switch.
3.Change the fuse.
4.Wait or cancel the time setting.
5.Pour out water of water tank, then
put it back.