Dorner iDrive 3200 Series, Инструкция по установке, эксплуатации и ремонту

Страница: 21 / 48

851-702 Rev. A 21 Dorner Mfg. Corp.
3200 Series iDrive Belt Conveyors
Preventive Maintenance and Adjustment
6. Remove two hex head screws (Figure 62, item 1) and
washers securing drive motor plate (Figure 62, item 2)
to conveyor.
Figure 62
Figure 62
7. Slide drive motor (Figure 63, item 1) and remove
timing belt (Figure 63, item 2) from drive motor gear
(Figure 63, item 3) .
Figure 63
Figure 63
8. Loosen two set screws (Figure 64, item 1) holding
drive motor gear (Figure 64, item 2) onto drive motor
shaft.
Figure 64
Figure 64
9. Remove drive motor gear (Figure 65, item 1) from
drive motor shaft (Figure 65, item 2) .
Figure 65
Figure 65
10. Remove drive motor from headplate assembly.
11. Replace motor.
12. Reinstall in reverse order of removal. (Refer to “Drive
Spindle Removal and Replacement” on page 18 for
timing belt tensioning.)
1
2
2
1
3
1
2
NOTE
Take note of the drive motor gear (Figure
65, item 1) placement. When reassembling
the drive motor gear, it should be
reassembled to the exact same location on
the shaft.
2
1