Dorner iDrive 3200 Series, Инструкция по установке, эксплуатации и ремонту

Страница: 18 / 48

Dorner Mfg. Corp. 18 851-702 Rev. A
3200 Series iDrive Belt Conveyors
Preventive Maintenance and Adjustment
4. Slide the transfer tail pulley assembly (Figure
49, item 1) out of the headplate on the opposite side.
Figure 49
Figure 49
5. Remove hex nuts (Figure 50, item 1) .
Figure 50
Figure 50
6. Remove support plates (Figure 51, item 1) and washers
(Figure 51, item 2) .
Figure 51
Figure 51
7. Remove pulleys (Figure 52, item 1) and additional
washers (Figure 52, item 2) .
Figure 52
Figure 52
8. To remove additional pulleys, repeat steps 6 through 7.
Pulley Replacement
Idler Pulley
To replace the idler pulley, reverse the “Idler Pulley
Removal” procedure on page 16.
Transfer Tail Pulley
To replace the transfer tail pulley, reverse the “Transfer Tail
Pulley Removal” procedure on page 17.
Drive Spindle Removal and
Replacement
Removal
1. Remove belt. (See “Belt Removal for Conveyor Without
Stands” on page 13 or “Belt Removal for Conveyor
With Stands” on page 13.)
2. Remove wear plate (Figure 53, item 1) by removing
plate fastening screws (Figure 53, item 2) on each side
and end of conveyor
Figure 53
Figure 53
1
1
2
1
1
2
A
WARNING
Exposed moving parts can cause severe
injury. LOCK OUT POWER before removing
guards or performing maintenance.
1
2