INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-644
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualifi ed auto technician
before attempting to perform any work you are not qualifi ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffi
c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION:
Refer to the appropriate shop manual for your vehicle to obtain specifi c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualifi ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
9
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
We appreciate your opinions regarding this product!
Please call our technical assistant with any challenges or suggestions
regarding the installation or operation of this product.
1-800-523-2492
STEP 10:
Operate the window up and down using the switch making sure that the glass
moves smoothly and is seated properly in the run channel.
STEP 11:
Disconnect the window switch.
STEP 12:
Reinstall the plastic water barrier making sure the wires are poking through the
correct holes.
STEP 13:
Reinstall the interior trim panel.
STEP 13a:
Starting at the top of the door frame, hang the panel on the top lip and move
into place making sure that the electrical wires are pushing through the proper holes in
the door panel. Make sure door handle is properly aligned with the hole in the door panel
and that the door lock rod protrudes through correct hole in door panel.
STEP 13b:
Reinstall the three 7mm bolts that hold the panel to the door frame.
STEP 13c:
Reconnect window switch electrical plugs and snap switch into place on the
door panel.
STEP 13d:
Maneuver handle bezel around door handle and snap into place.
STEP 13e:
Snap plastic mirror cover back into place.
STEP 14:
Perform a fi nal operational check of window regulator assembly by operating
the window up and down to ensure proper performance.