INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-644
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualifi ed auto technician
before attempting to perform any work you are not qualifi ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffi
c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION:
Refer to the appropriate shop manual for your vehicle to obtain specifi c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualifi ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
3
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 2:
With interior panel removed, peel back the plastic water barrier enough to be
able to remove the regulator. Do not damage or discard plastic barrier, it will need to be
reinstalled.
STEP 3:
Reconnect the window switch electrical connector.
STEP 3a:
If the window motor operates, move the window into a position where you
can access the 10mm bolts that hold the window guide clamps and go to step 5. If the
window motor does not operate, go to step 4.
STEP 4:
Cut the window regulator cable
with a cable cutter so that you can manually
move the window where you can access the
window guide bolts.
STEP 5:
Loosen the 10mm window guide
bolts enough so that the window can be
separated easily from the clamps. Do not
remove the bolts or loosen all the way. The
window glass needs to be supported by the
clamps until the glass is secured.