OUTER CAM
GROOVE AT 12 O'CLOCK
INNER CAM
LEFT HAND (LH)
1- HOLD TO PREVENT ROTATION.
2- ROTATE TO CHANGE
FROM LH TO RH.
GROOVE AT 6 O'CLOCK
RIGHT HAND (RH)
TAIL PIECE SHALL BE "SNAP" IN PLACE WITH
WIRE RING OPENING ROTATED AT 6 O'CLOCK.
STEP 2
STEP 1
REMOVE TAPE
CONNECT V1 TO
V2 (POWER)
CONNECT W1 TO W2
(COMMUNICATION
IF APPLICABLE)
AFTER CONNECTION,
6.
CABLES SHALL BE ROUTED
AROUND THE CLIPS
WARNING
ALIGN STUD AND TAIL PIECE
GENTLY INTO DEAD BOLT
TAIL PIECE MUST BE BELOW
DEADBOLT CENTER LINE
F
F
2
1
3
STEP 3
STEP 2
A
A
2
1
3
C
SECTION A-A
SCALE 1 : 4
DETAIL C
SCALE 1 : 1.5
TAB
STEP 4
STEP 5
GAP
KEEP CLEARANCE TO MINIMUM
TO FACILITATE INSTALLATION
OF COVER
G
SECTION F-F
SCALE 1 : 4
TAIL PIECE SHALL BE IN VERTICAL
POSITION & KNOB IN HORIZONTAL
POSITION.
STEP 1
KNOB
LH INSTALLATION
RH INSTALLATION
STEP 1
9.
INSTALL INSIDE COVER
5. ASSEMBLE TAIL PIECE
6. REMOVE INSIDE
COVER
7. ASSEMBLE OUTSIDE HOUSING
4. ADJUST LOCK HANDING ON OUTSIDE HOUSING ASSEMBLY
8A -
INSTALL INSIDE TRIM ASSEMBLY (VERTICAL MOUNTING ONLY) - FOR HORIZONTAL MOUNTING SEE 8B - SHEET 3 THEN
PROCEED WITH SECTION 9.
INSTALL INSIDE TRIM ON DOOR AS SHOWN BELOW, RUNNING CABLES THROUGH INSIDE TRIM BACKPLATE
LOWER
SLOT.
1.
CABLE SHALL BE PULL GENTLY TO ACCUMULATE ALL EXCESS WITHIN INSIDE TRIM.
INSTALL MOUNTING SCREW, 3X.
2.
BEFORE TIGHTENING THE SCREWS, DEADBOLT FUNCTIONALITY SHALL BE VALIDATED BY ROTATING TAIL PIECE FROM
3.
INSIDE. DEADBOLT SHALL MOVE SMOOTHLY.
ALL SCREWS SHALL BE TIGHTENED PROPERLY.
4.
INSTALL BATTERIES AFTER TIGHTENING ALL SCREWS AND CONNECTING WIRING V1 & V2 AND W1 & W2 IF APPLICABLE.
5.
HOLD INNER CAM IN PLACE, INNER CAM GROOVE ORIENTED AT 12 O'CLOCK.
1.
FOR RH LOCK, ROTATE OUTER CAM COUNTERCLOCKWISE UNTIL OUTER CAM GROOVE IS ORIENTED AT 6 O'CLOCK.
2.
FOR LH LOCK, ROTATE OUTER CAM CLOCKWISE UNTIL OUTER CAM GROOVE IS ORIENTED AT 12 O'CLOCK.
3.
STEP 2: MOVE THE COVER UPPWARD. TAIL PIECE MUST REMAIN
ENGAGED IN TURN KNOB.
STEP 3 : ENGAGE COVER'S TAB WITH BACK PLATE HOOK.
STEP 4: CLOSE COVER'S BOTTOM.
STEP 5: INSTALL SCREWS.
PK3705 - Rev 3
STEP 6: PROTECTIVE PLASTIC FILM SHALL BE REMOVED FROM
THE COVER, BOTH SIDE.
STEP 1: ENGAGE TAIL PIECE
