*941094-00*
941094-00
Cylinder cam in
this position with
key removed
NL
TL
TL Function
- Control remains unlocked
when key is removed.
NL Function
- Control relocks when key is
removed. Requires use of key to operate.
For NL function replace TL cylinder plate
(std. on all controls) with NL cylinder plate
(included in polybag) replacing screw and
washer.
Note: Control must be in locked position
when installing cylinder plate.
Mortise
cylinder
Cylinder locating
washer
Cylinder
nut
Hexagon mounting
extension
Socket set
screw
Figure 1
Figure 2
1.
Prepare door for exit device. See exit
device instructions for locations of
holes, backset (line X-X), and center
lines.
2.
Prepare door for control:
A.
Transfer line X-X from inside (exit
device side) of door to outside
(control side) of door. Use extra
care if edge of door is beveled.
Be sure line X-X is parallel to edge
of door.
Note: See back side of sheet for hole
preparation for metal or wood.
B.
Locate and prepare holes as
indicated.
3.
Install cylinder into control if required
(Figures 1 & 2). Insure cylinder cam is
set for required function and replace if
necessary.
4.
Install control and exit device to door.
5.
Test key, control, and device action.
#10 or #11 WDA
plate for wood door
application
Assemble set screw and hexagon mounting
extension this location for RHR top and bottom
Assemble set screw and hexagon mounting
extension this location for LHR top and bottom
941
094
_00
(8)
PRE
PUB
LIC
ATI
ON
REVIEW
COPY
RE
V. A
Controls for 33/35 Rim & 33/3527 Metal or Wood Doors
370T, 370L, 370T-BE, 370L-BE
Installation Instructions
© Allegion 2014
Printed in U.S.A.
941094-00 Rev. 01/14-b
Customer Service
1-877-671-7011
www.allegion.com/us
