CABLES SHALL BE PULLED GENTLY THROUGH INSIDE
1.
TRIM'S BACKPLATE TO ACCUMULATE ALL EXCESS
CABLES WITHIN THE INSIDE TRIM.
LH MOUNTING
INSTALL INSIDE COVER
10.
1
COVER PLATE AND INSIDE TRIM ASSEMBLY SHALL BE INSTALLED AS SHOWN WITH 3X SCREWS, ITEM 25.
LH
RH
CABLES SHALL BE PULLED GENTLY THROUGH INSIDE
1.
TRIM'S BACKPLATE TO ACCUMULATE ALL EXCESS
CABLES WITHIN THE INSIDE TRIM.
RH MOUNTING
CONNECT V1 TO
V2 (POWER)
8B - INSTALL INSIDE TRIM ASSEMBLY HORIZONTAL MOUNTING OPTION (IF APPLICABLE)
BEFORE TIGHTENING THE SCREWS VERIFY FUNCTIONALITY BY EXTRACTING AND RETRACTING THE DEADBOLT. DEADBOLT SHALL
1.
MOVE SMOOTHLY.
ALL SCREWS SHALL BE THIGHTEN PROPERLY.
2.
CONNECT BATTERIES AFTER TIGHTENING ALL SCREWS AND WIRING W1 & W2.
3.
POWER AND COMMUNICATION CABLES SHALL BE
CONNECTED AND ROUTED AS SHOWN.
LOCATING POST AND MOUNTING SCREWS SHALL BE
INSTALLED AS SHOWN.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.”
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.”
PK3705 - Rev 3
CONNECT W1 TO W2
(COMMUNICATION
IF APPLICABLE)
