12
P/N 731.018 Rev I • 05/18
©
copyright 2008-2018
dormakaba
Set Time Delay Values:
The Delay and Open Periods may be set up at this time or later by the Manager. To set the Time Delay Periods follow the
instructions below or refer to Manager Instructions 732.018.
1. Enter Manager combination and
hold down last digit of combination until lock double signals release and the LED
stays on
.
2.
PRESS 9
.
3. Enter two-digit Delay Period value (00 to 99 minutes) followed by the two-digit Open Period value (00 to 19 minutes).
4. Re-enter the Delay and Open Period values to confirm.
ACTIVATE THE LOCK
To complete the activation of the lock and freeze the configuration, the Manager combination MUST be changed. Please
note, SMR must be changed first or it will be lost.
To change the Manager combination, follow the steps below:
CAUTION:
Always perform this operation with the door open!
1. Enter the default Manager combination and hold down the last digit until unit double signals twice and the LED stays on.
2.
Press 0
.
3. Enter your NEW combination,
4. Re-enter your NEW combination to confirm.
5. The lock is now active and the configuration is frozen.
6. Test lock operation several times before closing the door.
NOTE:
If default combinations are used, it is recommended that they be changed. New combination will not be accepted if
it varies from the current combination by only one digit (+/-). When selecting a combination, do not use a birthday or other
predictable information that could give correlation between the user and the combination.
RESET THE LOCK
(Reset Box [P/N 6066] required.)
To change the lock settings after the configuration is frozen, you must reset the lock.
1. Remove battery.
2. Hold down the
0
key for at least 10 seconds to discharge all internal capacitors.
3. Connect Reset Box to BAT port on Lock.
4.
PRESS 1
.
If the lock opens, the factory reset is complete. If the lock does not open, disconnect the Reset Box and repeat steps 2
and 3.
5. Disconnect Reset Box.
The Lock is now in Factory mode, and is ready to be configured by the PC Software or through the keypad.
dormakaba USA Inc.
749 W. Short St.
Lexington KY 40508
T: 859 253 4744
F: 859 255 2655
Toll-free: 877 522 2627
www.dormakaba.us
